I very much enjoyed testing the Voopoo Drag S Pro and the Drag X Pro. Mode allows you to switch between Smart and RBA modes Once locked, the auto draw will still operate. Once selected using the fire button, the switch menu allows you to use the switch to either lock or turn off the device. Press the + and – buttons to enter the menu where the choices are Switch, Mode, and Exit Press the fire button and the – button to clear the puff counter Press the fire button five times to turn the device on and off Just like other Drag devices, the mods go into standby after a period of time and when you’re ready to use them again then you must press the fire button once before it will fire. The menu operation for both mods is somewhat simplified due to the addition of the One Button Switch. Length of current puff and Puff counter Set wattage and mode of operation( S= Smart/ R= RBA) TC will be available for download on the Voopoo website The word Drag and battery level indicator 96” TFT display the following information is given going from top to bottom. The airflow sensor on both kits is offset inside the pod receptacle so it’s not in line with the coil and is thus somewhat protected against any liquid leakage. I found the auto draw worked best with the airflow control mostly closed. Both mods now have an airflow sensor that allows the user to activate the mod by button firing or auto draw. Of course, above the airflow control there is the receptacle for the pod tank. There is a wide airflow slot as well as a single small hole that would be good for a tight MTL for those that like that. I very much like how it is built into the mod frame and we no longer have the rod sticking out for airflow adjustment like there have been on past versions. Above the leather is the new 360 degree airflow control. On the back is a nice leather like wrap with the words “Drag X Pro” or “Drag S Pro” stamped into the leather depending on which mod you are holding at the time. On the left side of the frame are the words “Designed by Voopoo” and on the right side are the words “Gene Chip inside”. Both mods have the same configuration on the front which has the fire button on top followed by the display screen, the + and – buttons, the new “One Switch”, and the USB-C charging/update port near the bottom. The Drag X and the Drag S are very similar in appearance with both kits coming with the same tank that holds 5.5ml of liquid. The Drag S has an internal 3000mah battery. This one is a TPP-DM1 and the one that came with the X is a DM3. 15 coil is not the same as the one that came with the Drag X. The X uses a replaceable battery and can be used with a 21700 battery or an 18650 battery with the included battery adapter. 15 ohm coil rated at 80-100 watts according to the literature and the. Inside of each kit was the mod, the new TPP X Pod Tank, two coils, USB-C charging cable, and user guide. Both of the units arrived in small boxes that are pretty standard packaging from Voopoo.
0 Comments
Leave a Reply. |